![]() |
#1
|
|||
|
|||
![]()
Hi,
Up until now I've used old or cheap garden hose trailed round the garden with puncture holes every so often, eventually these tend to split due to the water pressure and deteriorate exposed to the sun.Just bought a few reels of 16mm x 25m plastic irrigation pipe and a shed load of connectors, straights, Ts, bends etc, these push on. Are they supposed to be glued, clamped or neither They seem to be easy to pull off once they are pushed on, which is a bit worrying should our water pressure be high, which it usually is most of the time, I dont know what our water pressure measures in bars but I can fill a 5ltr water bottle in 7 seconds. I assume I need one of these connectors between the tap and water hose Any advice on this topic would be a great help. Please help. I did not find the right solution from the internet. References: http://www.andalucia.com/forums/viewtopic.php?t=34831 Motion graphics animation studio Thanks! |
![]() |
Thread Tools | |
Display Modes | |
|
|